Additional information
Model Number | 18650 Lithium Battery Capacity Tester Module |
---|---|
Type | Household Battery Tester |
DIY Supplies | ELECTRICAL |
Brand Name | KKMOON |
Origin | Mainland China |
Certification | NONE |
54.71 $
35 in stock
Model Number | 18650 Lithium Battery Capacity Tester Module |
---|---|
Type | Household Battery Tester |
DIY Supplies | ELECTRICAL |
Brand Name | KKMOON |
Origin | Mainland China |
Certification | NONE |
This product supports single channel internal resistance and capacity measurement; supports charging and up to 9 charging-and-discharging cycles in automatic mode. It not only can be used to charging battery, but also can be used to measure the battery internal resistance and capacity. And more important, it can be used to dispense battery capacity and run cycles.
Features:
Digital Display: 1.77inch digital display, clearly display the real time voltage, real time current, real time power, accumulated capacity, accumulated energy, status indication, operating mode, stop discharge voltage, number of cycles, battery internal resistance and accumulated time.
Multifunctional Design: It not only can be used to charging battery, but also can be used to measure the battery internal resistance and capacity. And more important, it can be used to dispense battery capacity and run cycles.
Three Working Modes Design: Preset automatic, charging and discharging three modes, select the corresponding mode, the program automatically run, the discharge current can be switched for ease of use.
Charging Function: External 5V power supplys, maximum 1A current through the charging chip when charging, and the charging process will record the capacity and energy amount charging time. Not suitable for charging LiFePO4 batteries.
Internal Resistance Test: The product uses the direct current 2-wire method to test the internal resistance of the battery, with high accuracy when the battery is fully charged.
Capacity Test: The capacity test is carried out by resistance discharge, and the results are only the capacity measured between the starts of the battery discharge during the test phase and the trigger stops. The cumulative capacity, energy and time are recorded during the discharge process.
Battery Capacity Division and Running Cycle: The battery capacity dividing and running cycle is a process of charging, discharging and recharging. The stopping voltage cannot be lower than 2.8V when in use, otherwise it cannot be charged and the program cannot run properly.
Data Clear Function: Automatic zeroing of capacity, energy and time data when switching off and switching modes.
Language Switching: Two working languages design, the factory default language is Chinese, but you can freely switch according to your preference.
Specifications:
Name: Battery Capacity Tester
Material: printed circuit board
Working power supplys: DC5V power supplys or 18650 battery need to prepared by yourself
Applicable battery: meet the stop discharge voltage of 2.5-3.5V, 2.8V starts 4.2V full battery are applicable too.
Power supplys interface: Type-C interface, power supplys cable self-provided C-port mobilephone cable
System language: Chinese default, English
Number of tests: 1-channel charging and discharging measurement right-hand battery position only
Internal resistance measurement: supported, using the direct current two-wire method to test internal resistance
Charging function: supported, full automatic cut-off charging LiFePO4 charging not supported
Discharge function: supported, automatic stops when conditions are met, discharge current is not adjustable
Automatic charging and discharging: supported, battery is fully-recharged at the end of automatic mode
Cycle charging and discharging: supported, 1~9 cycles adjustable only supported in auto mode
Status indication: supported
Stops discharge voltage: 2.5V, 2.6V, 2.7V, 2.8V, 2.9V, 3.0V, 3.1V, 3.2V, 3.3V, 3.4V, 3.5V, 11 levels adjustable
Discharge current: two-way resistor, max. 1A current, not adjustable, does not support independent transformation
Charging voltage: special battery charging chip control, max. 1A charging, full-charged voltage is 4.2V
Power failure save: only the setting parameters are saved, not the measurement data
Item size: 110 x 89 x 30mm / 4.33 x 3.50 x 1.18in
Item weight: 80g / 2.82ounce
Package size: 153 x 100 x 42mm / 6.02 x 3.94 x 1.65in
Package weight: 120g / 4.23ounce
Packing List:
1 x Battery Capacity Tester
1/2pcs Billing Meter Digital Display Multifunctional Billing Sockets High-resolution Intelligent Biller for Electrical Equipment Feature: 1. Real-time Monitoring: The measuring socket supports the measurement of parameters such as voltage, current, accumulated electricity, accumulated electricity bills, and current. 2. Only Two Function Buttons: Mode and up. The function interface is concise and clear, easy to understand and adjust. There is a reset hole in the middle. If you need to reprogram, just insert a paper clip into this hole. 3. High-resolution Digital Display with Backlight: The backlight can always be turned on or off after a delay of 20 [...]
45.46 $ Add to cartDigital LCD Display Blue DC 60V 100A Balance Voltage Battery Power Analyzer Watt Meter Checker Balancer Charger RC Tools Features: 1. The digital LCD screen provides clear digital readings. 2. Intermittent treatment up to 100 amps and continuous operation at 50 amps. 3. Connect the load to the battery to provide real-time battery charge readings. 4. Process 0 to 60 volts. Suitable for 12, 24, 36 and 48 volt battery pack systems. 5. Very low power consumption is 7 mA. More efficient than any other instrument. 6. Measure [...]
47.66 $ Add to cartAI DENTAL Buy More Save More Theme Promotion Series AI DENTAL Focus on Providing You with High-quality Dental Supplies Buy air turbine get rotor for free 【February 20th to December 31st 】 Q & A Q: What is the light source of this product?A: The light source is LED light of electric micromotor and fiber optic rod of the handpiece. Please choose the model with optical fiber.Q: Is this product compatible with my motor?A: The handpiece is international E-type connector. You just need to consider whether your motor has LED light.Q: Is this product the same as the original [...]
228.26 $ Add to cartEU Fasend Store - From Europe, Fast Send. Kaiweets HT206D Digital Clamp Meter True RMS 6000 Counts Highlights True-RMS clamp meter:This multimeter can accurately measure AC/DC Current, AC/DC Voltage, Frequency or Duty Cycle, Resistance, Capacitance and also provides Diode, Continuity and Temperature tests. True RMS for accurate measurements on non-linear loads. LowZ & LPF:Low input impedance helps prevent false readings due to ghost voltage. Low Pass Filter LPF for accurate measurement of variable frequency drive signals when measuring motors and transformers. To measure the current, you need to clamp the meter around one of the wires and not the [...]
97.59 $ Add to cart1pcs Billing Meter Digital Display Multifunctional Billing Sockets High-resolution Intelligent Biller for Electrical Equipment Feature: 1. Real-time Monitoring: The measuring socket supports the measurement of parameters such as voltage, current, accumulated electricity, accumulated electricity bills, and current. 2. Only Two Function Buttons: Mode and up. The function interface is concise and clear, easy to understand and adjust. There is a reset hole in the middle. If you need to reprogram, just insert a paper clip into this hole. 3. High-resolution Digital Display with Backlight: The backlight can always be turned on or off after a delay of 20 seconds, so [...]
50.69 $ Add to cartUT230B series power sockets can be inserted to monitor operation and power consumption of electrical appliances. The socket jacks are designed to meet the needs of different regions with proper certifications. UT230B series are ideal tools for maintaining equipment power consumption and managing energy saving in homes,offices ,schools ,and other places. Feature: LCD display, easy and clear for readings. 4 buttons to operate, easy and convenient to use. CO2 parameter setting and electricity price setting. Electric safety transfer and other functions are available by connecting this product to a common socket and then plugging the electrical appliance in this [...]
75.44 $ Add to cart1.8MHz-50MHz HF Shortwave Standing Wave Meter Aluminum Alloy 0.5W-120W FM AM CW SSB SWR Power Meter Type-C Charging with OLED Digital Display Feature: 1. Button functions: One button off buzzer function, one button switch between Chinese and English. One button display mode switching function, 5 modes can be switched at will 2. High quality material: The cover plate is made of aluminum, and the aluminum alloy shell is wear-resistant and corrosion-resistant, not easy to rust, and has a long service life. This tool, small in size, is very convenient for [...]
98.35 $ Add to cartFeatures: Contains 9 sets of power outage saving store current capacity and energy when power is off.Reopen the opportunity to accumulate the current capacity and energy used.Manual removal if no accumulation is required.Voltage current and capacity display on the same LCD screen, no need for cumbersome operations, only need to connect to the USB interface, you can monitor the phone’s charging status in real time.Intelligently memory charging capacity, can save the mAH input from 9 sets of charging devices after power off. Easy to view and check whether the charging device’s capacitance is true.U disk current detection, the working [...]
51.86 $ Add to cartLogarithmic Detector RF Signal Log Output Power Meter Controller Feature: 1. This power meter is designed with for ADI's chip and used for RF signal power detection. 2. Detection frequency range is 1-440MHz, 1-8000MHz, 1M-10GHz, 0.1-2.5GHz, which can detect an RF signal with a power of -55dBm to -0dBm, and convert this RF signal into DC voltage output. 3. The greater the RF signal amplitude or power, the higher the output voltage, and the output voltage is proportional to the logarithm of the input signal amplitude, which expands the dynamic range of the detected signal by 55dB. [...]
54.58 $ Add to cartMeasuring range: accuracy: 0uW~10.0uW: ±5Laser wavelength measurement range: 400nm~1100nmThe default switchable value of laser wavelength: 520nm, 633nm, 650nm, 780nm customizable wavelengthLCD display 4-digit LCD displaySampling rate: 0.5 secondsData storage: 199 groupsBattery power indicator: 4-level power displayLCD backlight off time: press the backlight key to turn offAutomatic shutdown: automatic shutdown after about 5 minutes of inactivitySound alarm: √Date and time: √USB data transmission: √Maximum value measurement: MAX/MIN/AVGOperating temperature range: 0~40°COperating humidity range: 80RH temperature range: -10C~50°CPower supply: 9V 6F22 Does not includedLCD size: 57 x 37mmBody [...]
289.73 $ Add to cartUT385 Laser Power Meter UT385 Laser power meter is used to measure the energy output of laser beams for testing or laser system applications. It uses detection sensor to determine the intensity of a laser beam's energy output. Features ● Precise laser sensor● Split design with retractable spring wire● LCD screen for clear readings ● Data storage function● Selectable and customizable wavelengths● Threshold alarm function● Low power consumption Parameter Specifications Range Certificates CE, RoHS Measurement range 0uW~39.99mW Measurement accuracy 0uW~10uW: ±5+0.3; 10uW~39.9mW: ±5 Laser wavelength range 400nm~1100nm Laser wavelength preset options 520nm, 633nm, 650nm, 780nm LCD display 4-digitLCD display [...]
292.65 $ Add to cartbody { font-size: 75; color: #000; font-family: Open line-height: 1.3; } dl { margin: 0px; width: 480px; float: left; } dt { width: 100px; height: 15px; float: left; } dd { width: 240px; height: 15px; float: left; } dl dt { margin: 0px; line-height: 22px; color: #474747; font-size: 14px; font-family: tahoma; } #product-desc { width: 100; height: 209px; } #description { width: 100; height: 50; [...]
53.64 $ Add to cartChcę coś kupić ale szukam informacji jak zamówić... |
Kupiłem coś ale chcę poznać status zamówienia... |
Odebrałem paczkę ale mam pytanie lub problem... |
Chcę dokonać zwrotu i potrzebuję informacji... |
Droptech Sp. z o.o. droptech.polska@gmail.com |
ul. Łódzka 118, Piotrków Tryb. Sprzedajemy tylko przez internet |
NIP: 7712911090 REGON 386758083 |
Wysyłka bezpośrednio od producenta lub dostawcy |
DARMOWA WYSYŁKA + ubezpiecznie dostawy + śledzenie przesyłki |
CAŁKOWITY ZWROT podczas reklamacji |
Reviews
There are no reviews yet.